Incorporates the ARM7TDMI® ARM® Thumb® Processor . Atmel’s AT91SAM7X/ is a member of a series of highly integrated Flash. Development Board for the Atmel AT91SAM7X Microcontroller trademarks or trademarks of ARM Ltd. I2C™ is a trademark of Koninklijke. Microchip AT91SAM7X ARM Microcontrollers – MCU are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for Microchip.
|Published (Last):||17 July 2005|
|PDF File Size:||7.63 Mb|
|ePub File Size:||9.93 Mb|
|Price:||Free* [*Free Regsitration Required]|
The driver included in the download uses the EMAC in its most basic configuration. This is in contrast to the lwIP demo, where mutual exclusion is explicitly handled by use of a semaphore at the at91sam7c256 interface level.
Each receive buffer is bytes. See the uIP documentation for further information. Please refer to the SAM7S demo documentation for more detailed information. If this is the case, then it is also likely that the project file has been silently corrupted and will need to be restored to its original state before it can be built even with an updated IAR version.
The size of each transmit buffer is equal to the uIP buffer size.
The demo applications included in the FreeRTOS download switch to supervisor mode prior to main being called. Therefore a ‘Check’ task is created whose job it is to ensure that no errors have been detected in any of the other tasks.
It waits for each packet to be acknowledged individually. Entering the IP address into the web browser obviously use the correct IP address for your system. Open a web browser on the connected computer.
See the Source Code Organization section for a description of the downloaded files and information on creating a new project. Click here to view a static menu.
Simply open the rtosdemo. This must be set appropriately for your hardware. See the Embedded Ethernet Examples List page for more information. The IP addresses used by the web browser computer and the prototyping board must be compatible.
This is demonstrated by the sample CGI scripts included in the source code download. The interaction is further simplified by the single buffer memory management of uIP. The embedded microcontroller Flash memory will automatically get programmed with the demo application, and the debugger will break at the reset vector address 0.
This demo – Consists entirely of open source software. Demonstrates the creation of dynamic data with a simple CGI scripting language written by Adam Dunkels. Building the demo application for debug Two project configurations are provided.
All the interrupt service routine does is signal to the uIP task via a semaphore that data is available for processing. To connect to the target: Functionality The demo application creates 33 tasks – consisting predominantly of the standard demo application tasks see the demo application section for details of the individual tasks. Use the tree menu to navigate groups of related pages. The target hardware will serve web pages to a standard web browser. See the Demo At91szm7x256 Hardware Setup notes above.
Performance is therefore greatly improved by transmitting dynamically generated data as one large packet, rather than multiple small packets. Not all the tasks update an LED so have no visible indication that they are operating correctly. Ensure an Ethernet cable is connected as described above.
The CGI script used to generate the table of tasks transmits the entire table in one packet and therefore loads quickly. The prototyping board should also allow the use of a standard Ethernet cable when connecting point to point, but I have not tested this configuration.
When executing correctly the demo application will behave as follows: The toggle rate increasing to ms indicates that the ‘Check’ task has discovered at least one error. Every three seconds the ‘Check’ task examines all the tasks in the system to ensure they are executing without error.
Users must at91saam7x256 themselves with the uIP license.